Reverse sensors.

Taff814 · Mar 8, 2018

Has anyone fitted reversing sensors to a D2 (2002)? If so, is there access to feed the sensor wires into the interior or will I have to drill a hole in the boot floor? I have a kit coming. Power will come from the live feed to the reversing light.
Any help would be greatly appreciated.

wammers · Mar 8, 2018

Just fit a tow bar and stop when you hear a crunch. Much easier.

Taff814 · Mar 8, 2018

Ha ha. I have a tow bar but I suspect the crunching of other cars in car parks might be frowned upon

Pawl · Mar 8, 2018

There's a grommeted hole in both left hand & right hand inner corner panels where the wiring for the rear light clusters comes out. They're about 6 inches below the lights & accessible from outside if you take an upper rear light out & from the inside if you pull the removable slotted vent panel out of the bottom rear of the side trims. you can feed wires down the channel & out underneath with the existing wiring to the rear bumper.

Hellastony · Mar 8, 2018

Pawl said:
There's a grommeted hole in both left hand & right hand inner corner panels where the wiring for the rear light clusters comes out. They're about 6 inches below the lights & accessible from outside if you take an upper rear light out & from the inside if you pull the removable slotted vent panel out of the bottom rear of the side trims. you can feed wires down the channel & out underneath with the existing wiring to the rear bumper.

+1, best way.

Tony

Taff814 · Mar 8, 2018

Thank you. That’ll be perfect as the control box needs to remain dry. Many thanks for your help

Reverse sensors.

Taff814

Member

wammers

No longer with us, RIP

Taff814

Member

Pawl

Well-Known Member

Hellastony

Active Member

Taff814

Member

Similar threads