Range rover p38 4.6 hse 1998 gearbox fault

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.

Stevenrangie

New Member
Posts
7
Location
Suffolk
Hello, I have a problem with my drive if I put it in D it doesn't drive until I rev it up to about 3000 rpm then it bites in sharp and comes up with gearbox fault, it feels like it's stuck in third and it's really down on power. Reverse gear works fine. If I clear the fault put it in D wait a second or so and give a small amount of revs it will pull away but it's like the clutch is slipping, when it reaches about 10 mph it engages and drives fine through all the gears and feels fine but as soon as I take it out of drive and put it back in its back to square one again.

Here are the readings I'm getting.

Fault 27
Output speed sensor, no signal. Fault NOT currently present and continuous.

I have replaced sensor and it still comes up?

Battery voltage

12.34 engine off
13.85 engine on
14..05 at the alternator

Transmission voltage

9.17 engine off
10.35 engine on

My scanner is the Eyehawk total

Steven.
 
Back
Top