Range rover p38 2.5 dse fuel problem

robtay1 · Mar 21, 2009

Can anyone help before I dive in and change everything. Engine not firing on 2.5 diesal . Suspect fuel pump or related matter. Are ther any considerations before changing fuel pump in respect of relays, fuses etc.
Any advice would be helpful.

thanks
JB

Datatek · Mar 21, 2009

Have you checked that you have fuel at the injectors under pressure?
Leak off pipes OK?
Lift pump running?

robtay1 · Mar 21, 2009

Thanks for the reply
I think all is well in that department. I did change the batteries in my key remote and I am wondering if something has gone wrong with the engine ecu not allowing the pump to work. I sthis a possiblitiy
Thanks JB

Datatek · Mar 22, 2009

I have read another thread where the engine turned over but did not start, I believe that was something to do with the Becm and engine ECU not talking to each other. I'm new to the P38 so still have a lot to learn.

Try a search on the site for the above thread or get it plugged in to read the fault codes.

steve's P38 RR · Mar 22, 2009

Datatek said:
I have read another thread where the engine turned over but did not start, I believe that was something to do with the Becm and engine ECU not talking to each other. I'm new to the P38 so still have a lot to learn.

Try a search on the site for the above thread or get it plugged in to read the fault codes.

Hi that is the prob i had when the cars battery kept going flat, you first need to check the lift pump is working by taking the feed pipe off the fuel filter and turn the ignition on and make sure you get a good flow of fuel out if there.

Range rover p38 2.5 dse fuel problem

robtay1

New Member

Datatek

Well-Known Member

robtay1

New Member

Datatek

Well-Known Member

steve's P38 RR

Active Member

Similar threads