Range Rover L322 No Drive!!

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Rangerovergav

Rangerovergav

New Member
Posts
4
Location
Sutton in Ashfield
Hi I'm Gav a Range Rover L322 owner

I was driving along fine all gear changes fine stopped at junction on roundabout went to pull off car revved with no drive. I switched off and on a few times managed to move enough to get over roundabout. Rolled it in to a car park and got recovered got home plugged in the Snap On Solus Ultra no codes on engine or gearbox but 3 in transfer box. These are as follows

0x5212 battery under voltage

0x52ED instr 2 lost from can

0x52F2 instr 3 lost from can

If I leave it a bit it will go in drive then after yards lose drive and all other gears

Anyone help please as I don't want to chase my tail and spend money I don't need to.
 
range rovers are all about spending money! Where's the screaming hair pulling emoji face thing!!
there are some real wizards on here buddy, there'll be one along in a bus soon! Good luck! Do you have and history on the box, I.e. Oil and filter changes? There is a long list of things to verify on the l322 before any decisions should be made about spending any money!
 
AFAIK transfer box electrics are just the hi lo actuator.

Maybe not fully engaging.

PowerfulUK have a vid on youtube about removing it and bench testing it.
 
That being said it looks like transfer box;)

Had same issue myself after disturbing a 'sleeping' hi lo......

Sh@t my pants, did a google, whipped off the actuator, stripped it, 10 seconds of stunned WTF moment as the planet gears fell across the floor, cleaned commutator, checked brushes, did a bench power up, re timed it for re entry, all worked ticketyboo.

Don't neglect switch, remove console and clean Coca Cola/Red Bull from the gubbins with contact cleaner.
 
Last edited:
Rangerovergav said:
Hi I'm Gav a Range Rover L322 owner

I was driving along fine all gear changes fine stopped at junction on roundabout went to pull off car revved with no drive. I switched off and on a few times managed to move enough to get over roundabout. Rolled it in to a car park and got recovered got home plugged in the Snap On Solus Ultra no codes on engine or gearbox but 3 in transfer box. These are as follows

0x5212 battery under voltage

0x52ED instr 2 lost from can

0x52F2 instr 3 lost from can

If I leave it a bit it will go in drive then after yards lose drive and all other gears

Anyone help please as I don't want to chase my tail and spend money I don't need to.
Click to expand...
Did you get this resolved? I have the same problem
 
He keen to watch this thread as I have just had mine recovered back home with same fault but found i had the 37 still fitted in the fusebox so don't understand how mine has drove at all since I bought it
 
You must log in or register to reply here.

Similar threads

D
No drive but grinding noise
Replies
8
Views
897
rebeccaSP91
rebeccaSP91
S
2001 range rover p38 auto gear dox issues
Replies
2
Views
645
kermit_rr
kermit_rr
B
L322 Range Rover l322 gearbox issue
2
Replies
24
Views
3K
rich28uk
rich28uk
G
L322 No communication with air suspension with diagnostics
Replies
3
Views
1K
Mark Piercy
Mark Piercy
BroncoJr
D2 V8 Auto no drive when hot
Replies
5
Views
575
BroncoJr
BroncoJr
Back
Top