Problems with spring conversion

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
C

Colin from Hull

Active Member
Posts
299
Hi, Can anyone help? Came home from work and a note through my letter box, from a lad in the village, he has bought a P Reg, Diesel, Auto, with a spring conversion on it, he problen is; When he puts his foot down to accelerate his box drops a gear (as it should) but then will only let go 35 mph and show this as a message on his dash, this doesnt always happen!!!! So has the conversion been done correctly regarding ECU and sensors any links so he could check it all out.
 
there is a ecu fooler unit required to tel the becm and other ecus all is well if that is not fitted then you will get this fault
 
Hi, Could you tell where he could get one of these? Do you know how to fit these? Is it just plug in cable from BeCM to ECU. Can you explain in more detail, i will be printing these replies for him to read, so instructions and checks he could carry out would be helpful.
 
He should have got one with his conversion kit, where did he get it from
It plugs into the suspension ECU under the seat to stop the message flashing on the dash
 
You dont have to go to any expence. You just need to make a couple of jumper wires to go to Ecu pins 7 to 18 and 25 to 1.

Now bare in mind this is from memory so its worth checking.
 
Hi, Thanks for info, so do you the suspension ECU and the jumper wire are (from and too) PINS within that ECU, other replies have mentioned the BeCM. Also the ECU in question were is it located.
 
You must log in or register to reply here.

Similar threads

D
Steve's Land Raft
4 5 6
Replies
104
Views
8K
Dauphproto
D
Col-Sanders
Hello from Cumbria!
Replies
11
Views
783
Hippo
Hippo
Henry_b
The ZF 6HP26 Service Procedure.
Replies
13
Views
31K
RobKneeland
R
Sunray-I40
Defender Air Intake, Power & Fuel Efficiency
Replies
3
Views
3K
bankz5152
bankz5152
ant.7
whats it worth 90 project ????
Replies
6
Views
751
GINGE
GINGE
Back
Top