no start no crank after button pressed

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
M

mrmotorvator

New Member
Posts
6
i have a tdv8 3.6 2010 and it will not start tested starter and works fine no power to fuel pump also tested and works fine
 
no aftermarket alarm you put fob on centre console press start button nothing happens dash is lit .it says press brake to start when you do the ignition turns off . brake lights work ok switch renewed if i give 12v to the energizer wire on the starter engine turns over but does not start . no 12v feed to fuel pump
 
Then it sounds like a problem with the brake pedal switch or wiring, there are two sets of contacts, one normally open, one normally closed. If the two do not change state correctly then you'll get the symptoms you describe in your second post.
Are you a trader?
 
im a retired mechanic mot tester not in the trade anymore .i renewed the brake light switch still same if i feed the tank pump with a live feed and also give a feed to starter it will run .otherwise just turns off
 
You must log in or register to reply here.

Similar threads

feyniriel
P38 windshield wiper liquid not spraying?
Replies
9
Views
612
pwood999
pwood999
W
Cranks but not starting 2012 4.4 tdv8
2
Replies
27
Views
565
Freddie17
Freddie17
F
P38 DSE loss of power when driving
2
Replies
34
Views
2K
Tibo W
T
kricktd5
L332 abs/ HDC
Replies
1
Views
873
Datatek
Datatek
R
2000 Thor 4.6 fuel/starting problems
Replies
5
Views
526
richardtamps
R
Back
Top