New fuel tank hose

scottonthefen · Jan 24, 2019

I'm having a job getting a new fuel intake hose fit. No laughing!

I can get it on the tank, or on the filler neck, but not both! I've cut it down to the size of the old one but it's too stiff to bend into place. Can I soak it in hot water or something to make it more malleable? Any other tricks or suggestions? I thought this would be a straight-foward job for once..

Flossie · Jan 24, 2019

Yes, put it in hot water.

Bobsticle · Jan 24, 2019

No fun in water. Get the blow torch out

Blackburn · Jan 24, 2019

can you loosen your tank mounting bolts and lower it some to give you space.

scottonthefen · Jan 24, 2019

Yeah.. when I get the rear axle back on and I can roll her out the garage..

I started by pushing the hoses down and through onto the tank with it in place and then tried to fit the filler neck last, but I think I need to drop the tank as you suggest, fit the hoses and filler neck, and then lift the tank onto the hoses - which I'm hoping I can do with a jack and if the hoses are already in place and won't move away as I raise the tank. It's a job by yourself. They've no bend to them hardly at all when new. I'll try the hot water when I try again. Might leave the blow torch though Bobsticle

rob1miles · Jan 24, 2019

If its just the ends you can use a saucepan full of boilng water and put them in that, or if its the whole lot then slowly coil it in like pasta then fit it while its still soft.

New fuel tank hose

scottonthefen

Well-Known Member

Flossie

Well-Known Member

Bobsticle

De Villes Advocaat

Blackburn

Well-Known Member

scottonthefen

Well-Known Member

rob1miles

Well-Known Member

Similar threads