- Posts
- 83,296
- Location
- Embasinga stocæ
Crawling around under JP's motor tonite (as one does) and noticed that on his bellhousing, where the clutch slave cylinder sits ( underneath) is a machined hole, about 35 to 40mm in diameter. Now i checked both of my 200TDi's and neither if mine have this hole, and i reckon that when wading, this us gonna allow loads of ****ty water into the clutch area. Do any if you folks have this ere hole, and if so, wots it for? I reckon it should be blanked with a rubber grommet or summat, wot do yooz reckon?
We also found that all the filler plugs are done up so tight, that neither of us could undo them, even with a breaker bar
.
We also found that all the filler plugs are done up so tight, that neither of us could undo them, even with a breaker bar
.
![[JP]](/data/avatars/m/29/29578.jpg?1437394565){kind=avatar}
