Disco 1 Glow plug relay

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.

Steviecops

Active Member
Full Member
Posts
802
Location
Colchester
Changed glow plugs the other day but suspect they aren't doing their job. I checked the relay and it's clicking on when the ignition is switched on, but can't hear it clicking off. Batteries in my multi meter are flat so can't test voltage at the plugs until tomorrow.
Any ideas?
 
A relay can make a clunk when it's energised, but even then there's no guarantee that the contacts are making correctly.
As said by the others, the only way is to put fresh batteries in your DMM and do the tests.
Exactly :D but then on vehicle electrics I prefer my analogue meter :) the fluctuation of the Fluke doesn't help for a speedy diagnosis.
 
Last edited:
Ok, just checked with my cheapo dmm and when ignition is switched on, the voltage hovers between 11 and 13 volts, then drops away to nothing after about 5 seconds. So I guess all is working as it should?
 
Ok, just checked with my cheapo dmm and when ignition is switched on, the voltage hovers between 11 and 13 volts, then drops away to nothing after about 5 seconds. So I guess all is working as it should?

That would seem to rule out the relay and the circuit driving it.
If you seriously suspect one or more of your glow plugs, you can either check the resistance of each one individually, disconnected from the rest of the circuit, you'll be looking for a low resistance value, or you can pull them and check that each one heats up when you stick 12 volts across it. DO NOT HOLD ON TO THE GLOW PLUG WHILE DOING THIS unless you have asbestos gloves! They should get very hot, very quickly.
 
Last edited:
That would seem to rule out the relay and the ECU circuit driving it. The ECU, by the way works out how long the glow plugs should be activated based on the measured temperature of the engine coolant ..... thought I'd just sling that in as a bit of additional information.
If you seriously suspect one or more of your glow plugs, you can either check the resistance of each one individually, disconnected from the rest of the circuit, you'll be looking for a low resistance value, or you can pull them and check that each one heats up when you stick 12 volts across it. DO NOT HOLD ON TO THE GLOW PLUG WHILE DOING THIS unless you have asbestos gloves! They should get very hot, very quickly.

Well that sounds interesting if it's true, so where's the ecu and the coolant sensor located then, as my belief is the Tdi uses just a timer relay.
 
Ok, just checked with my cheapo dmm and when ignition is switched on, the voltage hovers between 11 and 13 volts, then drops away to nothing after about 5 seconds. So I guess all is working as it should?
where did you measure this cos that's important... were the glow plugs connected when you measured?
 
Well that sounds interesting if it's true, so where's the ecu and the coolant sensor located then, as my belief is the Tdi uses just a timer relay.
Just because you seem to always want to have the last word, I've edited my post to remove any and all references to the Td5 engine. The rest of the post refers to just ordinary measuring methods which would apply to any situation of a relay switching a heating element.
 
It is on the Td5.
And I am awake! Are you? it took all of 17 minutes to reply to my retraction.

Replying to forum posts is never my priority even if I had the time, but I don't I have better things to do such as work for a living, tonight writing risk assessments and method statements of two site meetings tomorrow.




Sent from my iPad Air on a train.
 
Back
Top