Freelander Fault Code

Have just replaced front n/s drive shaft complete with reluctor ring and abs sensor and the usual 3 are still on. The red handbrake light which had been on permanently is now off though so something's back to normal. Went for a test run and the 3 are staying on. Selecting HDC doesn't show up the green light and the switch on the stick and brake switch are both ok. Have put it on a Launch X431 and cleared the old air gap and no voltage faults but it's coming up with 'refer to manual' and 'C1dc0 (62,63,5d,c0)'. Have even been through the OBDII options on the Launch but still showing when I go back to model specific. Any ideas? MOT due so needs done. BTW its a 2001 TD4.

Just run it on live datastream. Rear o/s sensor - the only one which hasn't been done - yet! The fault code is actually Cldc0. Oh, well here we go again.................

hippolover said:

Just run it on live datastream. Rear o/s sensor - the only one which hasn't been done - yet! The fault code is actually Cldc0. Oh, well here we go again.................

Click to expand...

Hi,

I know this is now a few years old but the fault code you have is the same as mine.

Did you resolve this issue? If so, how?

Thank you

Regards
Bev