Freelander 1 Start Issue

arnopretorius

Member

Posts

36

Location

South Africa

• Sep 9, 2020

• #1

Hello Guys

Hope all is well..

So I have a bit of a weird issue with my Freelander 1 1.8. On Monday I started getting some issue with the starter and I took it out and took it to a guy to get sorted... Starter is all sorted now. So this morning I decided to quickly put it back in the car and then it started with a weird issue. As soon as the car starts it cuts out immediately.. I then leave it for about 2 minutes and then the same thing happens.. I did remove all the leads from the battery when I removed the starter due to fault finding.

Any advice will be appreciated..

Regards

 

Nodge68

Well-Known Member

Posts

32,954

Location

Cornwall

• Sep 10, 2020

• #2

Check the basics like fuses first. Did you disturb the crank sensor while you were messing with the starter?

 

C

Colthebrummie

Well-Known Member

Posts

9,870

Location

Thatcham

• Sep 10, 2020

• #3

Have you got fuel in it?

Col

 

Nodge68

Well-Known Member

Posts

32,954

Location

Cornwall

• Sep 10, 2020

• #4

Colthebrummie said:

Have you got fuel in it?

Col

Click to expand...

Hopefully . But it's possible the fuel cut-off has been tripped when working in that area.

 

arnopretorius

Member

Posts

36

Location

South Africa

• Sep 10, 2020

• #5

Hi Guys

I have bypassed the cut-off switch and no luck... I cant remember bumping the crank sensor or anything like that....

 

arnopretorius

Member

Posts

36

Location

South Africa

• Sep 16, 2020

• #6

Hi Guys

So I still have an issue with my Landy..
I have checked all the fuses and relays and I have also replaced the crank sensor and still no luck..

Once the car starts it cuts out immediately....

Any new ideas for me to look at?

 

C

Colthebrummie

Well-Known Member

Posts

9,870

Location

Thatcham

• Sep 17, 2020

• #7

Although it's a bit unlikely, it maybe faulty spark plugs or coils.

Col

 

Nodge68

Well-Known Member

Posts

32,954

Location

Cornwall

• Sep 17, 2020

• #8

arnopretorius said:

Once the car starts it cuts out immediately

Click to expand...

That's reminiscent of an immobiliser data issue, where the code from the immobiliser module isn't being received, or recognised by the engine ECU.

 

arnopretorius

Member

Posts

36

Location

South Africa

• Sep 17, 2020

• #9

Hi Nodge

Thanks for your reply...

is there anything I can do to test this?

 

Nodge68

Well-Known Member

Posts

32,954

Location

Cornwall

• Sep 18, 2020

• #10

arnopretorius said:

Hi Nodge

Thanks for your reply...

is there anything I can do to test this?

Click to expand...

There's a way to put the ECU and alarm module back in synchronisation, but it needs something like a Hawkeye or other suitable code reader to do it.

This is assuming they are actually out of synchronisation. It could be that the engine ECU isn't getting the run signal, which means there's a break in the data line somewhere.
I think the place to start is the data connections, which includes the dashboard and ABS module, all of which route information around the data bus.

 

Hippo

Lord Hippo

Posts

53,956

• Sep 18, 2020

• #11

If the engine and immobiliser rolling security code is out of sync then you'll get error code P1672. I had it previously when this happened to my FL1.