Found this near aircon compressor

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.

chris7063

Member
Posts
25
image.jpg
image.jpg Would this be why my Aircon is not working
Chris
 
Yes, there is a small bolt that holds the clutch to the pulley, looks like yours is missing.

I think it's an M8 bolt but for sure it's metric.[/QUOTE
Thanks for that,I have plenty of metric bolts,do I need a certain length ,and do I need any washers or spring washers?

How does the clutch work ?if I tighten the bolt how can it pull together.
Chris]
 
A local garage has put a bolt in,but no shims,so its working all the time ,is this ok,or should i fit some shims in.Are they the same as washers?
Chris
 
When ours separated a year ago, I just swopped the pulley from a good compressor & used the bolt & washer it had in it. The washer didn't appear special & was the same thickness you'd expect for the size (M4 or M5?)
 
Thanks Dieseldog for the video very helpfull,
When ours separated a year ago, I just swopped the pulley from a good compressor & used the bolt & washer it had in it. The washer didn't appear special & was the same thickness you'd expect for the size (M4 or M5?)
Pawl
 
When ours separated a year ago, I just swopped the pulley from a good compressor & used the bolt & washer it had in it. The washer didn't appear special & was the same thickness you'd expect for the size (M4 or M5?)
I think I'm being too fussy,time to put in a washer and see if it switches off,
 
Back
Top