ironie
Well-Known Member
- Posts
- 526
- Location
- west midlands
I replaced the o\s front bearings several weeks ago and did a quicky (read sloppy) replace of swivel seal
by nipping the new seal and cleaning the landing and rtv'g it in. while cleaning the landing I hooked this out.
![20180922_112905[1].jpg](https://www.landyzone.co.uk/attachments/20180922_112905-1-jpg.159260/ "20180922_112905[1].jpg")
I have looked at several good videos and exploded assembly pictures and can't figure out what it is.
it is both too small and insubstantial to be part of the needle-bearing.
Another Landy enthusiast and professional mechanic looked at it and said it might be a cir-clip from the axle but his certainty level was pretty low. Any ideas mates?
by nipping the new seal and cleaning the landing and rtv'g it in. while cleaning the landing I hooked this out.
I have looked at several good videos and exploded assembly pictures and can't figure out what it is.
it is both too small and insubstantial to be part of the needle-bearing.
Another Landy enthusiast and professional mechanic looked at it and said it might be a cir-clip from the axle but his certainty level was pretty low. Any ideas mates?
