Fitting safari snorkel

Hi can anyone advise on what fittings to use to attach the snorkel to the wing and windscreen pillar? Bought used so no fixings supplied, any suggestions appreciated cheers

If memory serves (it was a few years ago I did mine) the part that fits to the wing has studs, so you just need some washers and matching nuts.

The part that runs up the pillar should have a bracket and would be fixed with short screws. Just line it up and do pilot holes then screw into. Beware though, the interior light wires run inside that pillar. So make sure you remove the trim on the inside of that that pillar and pull them to one side before drilling/screwing. The purple one is perm fused live so you shorting it out will blow a fuse for sure.

Cheers for that mundungus I will have a go at that when it eventually stops raining lol

If its on a 200 dont forget to remove the inner wing bits and seal them up as well, especially the dump valve rubber nipple, no point having a snorkel if water can get in.
Use all stainless screws.
I think on mine I used cap headed allen bolts through the snorkel into the wing.

It's a 300, am replacing metal pipe snorkel with a safari so everything's already there to fit straight on, do you use nuts on the bolts or are they just self tappers? Thanks