Fitting individual seats to 60/40 frames?

At some point I want to change the very uncomfortable 60/40 bench seats in the back of my 110 for the Classic Exmoor Trim high backs but you need the individual split seat frames which are tough to find and seem a tad difficult to fit (getting all the brackets etc...).

I was wondering if it would be possible to modify the "60" part of the seat frame to accommodate one high back seat and one standard low back seat. Using some kind of steel plate bolted/welded to the frame and drilled accordingly to fit the new seats?

Even a photograph of the longer part would do! Anyone?

Hi , there is some one that does a kit to replace the 60/40 bench seat in the back I think its Bearmach, have seen them on ebay but I think they were a few hundred pounds. I've just fitted high backs to my individual seat frames , what did you want a photo of ? Should be able to do it weld a strip across to fit the seat base then a plate on the side to fit the lock part might need a bit of strengthening.
cheers Ian

Not seen anything? Been searching for ages!

I photo of the 60 part of the frame, save me stripping my own seats down!

Sorry mate I've got individual ones so can't help you with that one , but any photos or measurements you want of the individual seat bases , backs or frames I can help you with.
Cheers Ian

Just remembered on eBay last night there was a set of seats looked like heritage style in very good nick were at 100 quid the 2nd row were the tracker style don't know if they're any good to you.
Cheers Ian

Chee4s! Ill have a gander

Just in case you didn't find them here's a linky http://www.ebay.co.uk/itm/Land-Rove...060989?hash=item46613c6dfd:g:gtQAAOSww3tY64Zx