Fitting 200tdi in 90
- Thread starter Andra
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
tottot
Well-Known Member
- Posts
- 8,082
- Location
- west wales coast
What are you lifting it with? I made my own lifting eye for the rear of the head. Just a bit of quarter inch plate with holes for the small bolts to the head and a larger one for the lifting shackle. Engine needs to be balenced to go in.
flat
Well-Known Member
- Posts
- 9,075
- Location
- Far away from you!!
There is a lifting eye for the rear. It bolts on to the head. I did the same as above
Rougharse Racing
Well-Known Member
- Posts
- 883
- Location
- The Grim North
There should be a couple of lifting eyes on the engine that you are going to take out, assuming that it is a 4 cylinder engine, they should bolt onto the tdi engine.
Flossie
Well-Known Member
- Posts
- 11,053
- Location
- Shropshire
My disco engine has one fitted under two of the head bolts lhs between number 3 and 4 injector iirc. I've also knocked one up out of some scrap flat plate made to fit the two bolt holes rear of the head once.
