Electrickery!!!!

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
The Don

The Don

Active Member
Posts
142
Location
The South
Afternoon all,
Right iv got a new problem, me starter motor doesn't want to work for some reason. When you turn the key in the ignition all the usual lights light up, but nothing from the starter motor, its as though theres no power going to it at all. Iv followed the wires from the starter motor up through the bulkhead to behind the dials on the dash, all seem to be fine and undamaged.

I absolutely hate electrics, so i was wonderin if any of you have any ideas?
 
find the solenoid, usually near the battery if it's a standard petrol and check the small wire has +12v on it when you turn the ignition key

the large wire from the starter will run back to it if you can't find it
 
Might be earthing problem. If your setup is the same as mine, I have a ground from the starter to the chassis - make sure the lead itself is decent - clean up the terminals on the lead and where it attaches.

If you have got a second pair of hands might be worth seeing if the voltage drops when you turn the key.

Failing that, I would take the starter off and connect it directly to battery to test it.
 
already tried earthing it, hooked up a jump lead from the -ve on the battery to the block itself, made no difference. I think I might have to take it off tomorow!!!
 
rustyrhinos said:
M

Failing that, I would take the starter off and connect it directly to battery to test it.
Click to expand...

think it's a bit hasty taking the starter off especially when the solenoid has +12v across it yet isn't clicking

get a spanner and short across the large solenoid terminals first to see if the starter turns
 
right, that shorting seems to work, it turned itself over fine. So am i right in thinking that the problem lyes in the ignition, as i have already checked the wires?
 
The Don said:
right, that shorting seems to work, it turned itself over fine. So am i right in thinking that the problem lyes in the ignition, as i have already checked the wires?
Click to expand...

nope

if you get 12v on the small wire that is attached to the solenoid when you turn the ignition key to the "start" position it means the solenoid isn't working - it's just a heavy duty relay

would be worth taking it off, cleaning all the connections (especially the smaller coil feed) and try it on the bench before you finally can condemn it
 
Right, checked solenoid nd guess wot...its ****ed. Once again sean you have proven that you really should be the dictator of the world!!!
:praise:
 
hi im starting work on my "new" landrover series 2a/3 and the indicators work but dont flash :/ . i assume i need a new flasher unit but i want to check the earth first before i go to the hassle of replacing it im not sure where it shoud earth or how to do it realy any guidence would be muchly appreaciated :)
 
You must log in or register to reply here.

Similar threads

S
Trouble with ignition switch wiring
Replies
11
Views
1K
tottot
tottot
S
starter motor questions
Replies
17
Views
2K
McBoon
McBoon
S
Lucas Starter Motor on Freelander 1
Replies
11
Views
732
Andy Warren
Andy Warren
S
order of installation inside the cabin
Replies
5
Views
612
sprie
S
S
esoteric question about ignition
Replies
1
Views
413
boguing
boguing
Back
Top