Eas problem Need advice

At first the pump ran only short time when started and then only for a 2-3 sec after a long time and no fault message at all Fault message came first when i had put some walves on the airlines to pump it manualy and drowe ower 35 What i have done allready is chnging and renewing valve block new compressor and ease driver box with pressure swiths last trying was replace the computre placed under seat and check the fuse box This have taken a while and not all done at the same time and allways in between pumped up manaly and the strange thing is that then there is no fault message when valve box and pump are disconnected But when ewrything is connected pump runs a few sec and then there is fault message I also renewed old pump and walve box and tryed it and it is still the same
Rover dealers here do not know what is a matter but my eas Buddy gives me all possible faults it can find and clears it

What to do I have no ideas anymore and would rather not replace eas with springs
My english is **** and i appologise for that

Jumping straight in with a question, with no introduction is a bit rude...!!!

What vehicle is it? L320, L322, P38A, Classic???

What year - All the different Model Years have slight differences....

Which Engine Type - 3.5, 3.9, 4.0, 4.2LSE, 4.2S/C, 4.4, 4.6, 2.5TD, TDV6, TDV8....

it would help

If it's a P38 the problem is unlikely to be the ECU, it's one of the few reliable bits.

Give us a quick introduction and a few vehicle details, it will help.

Anyway welcome to lz mate, looks like this is giving you a headache. You are right not to give up on the EAS and fit coils.

Have you doen all the checks that are listed in the 'How to' section of the forum?

Stu

Maybe not headace but sleepless nights
I did earlier introudece myself when i registered here in january
It is RR p38 SE with 4,0 engine

I live in Iceland and this is not my first RR I had earlier a few classics With a lot of problems there do not exist in this one but have been replaced with Eas problems instead