Drag links and track rods

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.

Headtester

Active Member
Posts
581
Location
Ruislip
Evening all

I've got a knocking noise coming from the front end of my Disco when I turn. Having looked at Rave and searched on Landyzone I think I've got the different parts identified properly but wanted to check first.

Is the Drag Link the rod at the front that goes from the steering box drop arm to the front of the nearside wheel?

Is the Track Rod the longer rod that links the rear of both front wheels?

I think it's the Drag Link ball joint on the nearside that's gone but I'm inclined to replace the whole thing. Is there anything else I should consider - such as the Panhard Rod bushes? - How would I check them?

Any help, advice or useful links would be appreciated.

Cheers
 
I know we've all been busy with getting used to the new look forum but has anyone got any ideas about drag links and track rods?
 
Thanks DiscoPol - it appears only the drag link ball is clunking but is it worth replacing both drag link and track rod or would you do them one at a time?
 
Thanks Ratty. On one end of the rods the ball joint is removable, the other end is fixed or pressed on to the main arm so I'll have to replace the whole unit. They're about £50 each for the whole assembly.
 
Changed both drag link and track rod today, two of the joints came off easily. I had to grind one of the others off and drill through the last one to get a pin in to hold it still whilst I undid the bolt.
It drives a lot better, I just need to centralise the steering wheel now - job for tomorrow as I've had enough for today.
 
No - went with OEM ones in the end, needed to get it fixed sooner rather than later and the local indy dealer had them in stock
 
Our D1 currently has a front end rattle.
It's the brake pads moving around in the caliper. I'm not buying mintex pads again. They last 5 minutes and this latest set aren't even big enough.
 
Should you get the tracking checked after changing the drag link?
I did.
Yes I plan to get the tracking checked - I'd measured the new and old lengths of both the drag link and the track rod assemblies to it's pretty close but probably still needs tweaking.
 
Back
Top