disco 2 snaking
- Thread starter ian0609
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
David Pye
Active Member
- Posts
- 623
- Location
- Newcastle Upon Tyne
Panhard rod bushes?
andymach23
Active Member
- Posts
- 265
The handling on my TD5 was very poor and it turned out to be uneven wear on the front tyres. Even though the car was tracking ok, the tyres were messing things up. This was particularly obvious on cornering. I stuck the rear wheels on the front and all is well.
Some threads on the forums lately about cars handling badly after getting new different tyres for only 1 axle. It seems the TD5 needs the same tyres on both axles.
Cheers, Andy
Some threads on the forums lately about cars handling badly after getting new different tyres for only 1 axle. It seems the TD5 needs the same tyres on both axles.
Cheers, Andy
Scruffyhippo
New Member
- Posts
- 120
- Location
- Essex UK
i agree with Andy on the tyre wear also get your tyres/wheels re-balanced can make hell of a difference.
thebiglad
Well-Known Member
- Posts
- 7,387
- Location
- Central France
WSLR
New Member
- Posts
- 336
- Location
- Wellington, Somerset, UK
As well as the above, check the airsprings are holding pressure at the rear.
pat murphy
Active Member
- Posts
- 342
panhard rod
David Pye
Active Member
- Posts
- 623
- Location
- Newcastle Upon Tyne
They aren't particularly hard to replace to be honest, provided you have a decent breaker bar and a reasonably large torque wrench.
Need a new pair of locknuts really. Set of polybushes, and you can remove the old bushes by burning the rubber out and then hacksawing through the outer sleeve to collapse it before driving it out. Some people swear by polys, some swear against em, so pays your money and makes your choice ;-)
David
Need a new pair of locknuts really. Set of polybushes, and you can remove the old bushes by burning the rubber out and then hacksawing through the outer sleeve to collapse it before driving it out. Some people swear by polys, some swear against em, so pays your money and makes your choice ;-)
David
Panhard rod bushes, just had the same problem. needed a set quickly so had to buy some sh.tpart ones, lasted 2 days greenlaning then nearly put us off the road on the way home, completely knackered! just fitted a set of poly's.
you don't need to burn them out, with the right sized sockets to use as a drift etc, they'll press out in a vice easy enough.
you don't need to burn them out, with the right sized sockets to use as a drift etc, they'll press out in a vice easy enough.
johnny curt 1
Well-Known Member
- Posts
- 9,118
- Location
- manchester
i found out that tyre fitting places only balance wheels to the nearest 5gram (minimum by law) ask and make sure they do it spot on its like being on rails compared to usual me bro used to work at quick fit and i regularly used to go there on me days off to tinker with me landy evrything was for free exept helping out when they got busy
If you've got access to a decent vice and selection of sockets to use as drifts, you should easy do them in an hour.
Rather than put the metalastatic bushes back in, I fitted poly ones, these you can push in by hand.
Land Rover Defender / Disco Panhard Rod Poly Bush Kit on eBay (end time 28-Sep-10 17:46:37 BST)
