D2 pre facelift bias plate and springs..

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
D

Descapri

Active Member
Posts
51
When you set off to sort a normally straight forward little job and find Mr Magoo was there before you 😂

Centre console with broken tabs screws missing etc, damping foam missing, center plate usually held on with rivets had little 7/8 millimetre bolts inserted which is fine except they were for show as the plate lifted straight off as not attached to anything finally the bolts that hold the bias plate in place were slightly rounded off which was hilarious.. they obviously gave up at this point and left the broken plate neatly in place for the next guy to sort out... 😉
 

Attachments

  • 20240527_142252.jpg
    20240527_142252.jpg
    288.1 KB · Views: 82
  • 20240527_143015.jpg
    20240527_143015.jpg
    259.4 KB · Views: 88
Last time I did this it broke within 9 months. So the next one I welded a support to it, been years now, even moved it from my old written off 95 to my current 99 .
Wish I'd thought about the rivnut option, I just riveted it all back. I unseized the difflock while I was there. Always with greasing it up while you're there..lol 👍😁👍
 
You must log in or register to reply here.

Similar threads

frostythor
Replace bias plate
Replies
0
Views
911
frostythor
frostythor
monkfish24
Freelander 1 Rear Drum rebuild
Replies
2
Views
2K
Jayridium
J
S
Timing Cover change woes, advice and some questions!
Replies
2
Views
643
Retroanaconda
Retroanaconda
Saint.V8
L322 HEVAC - Matrix, FSR and Blower removal....How To....
Replies
7
Views
8K
Don12345
D
TheWoodsmane
Disco 2 Rear Step Removal
Replies
14
Views
5K
TheWoodsmane
TheWoodsmane
Back
Top