Series 3 Blade fuse box

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
A1yxll80

A1yxll80

Member
Posts
75
Location
Gtr Manchester
I’m in dire need of some help from you knowledgeable lot....

So I’ve upgraded from the the Lucas glass type fuses to led blade ones, however I’m struggling to get my head around getting power to the box? I for some reason can’t find a permanent power wire although I do have power at the starter motor into the bulkhead? Does a wire have to go into the terminal at the bottom in the picture? or just same as the glass type fuse?
 

Attachments

  • CD1F4197-FD75-487B-A3FF-DDE185C93C4B.png
    CD1F4197-FD75-487B-A3FF-DDE185C93C4B.png
    104.2 KB · Views: 166
This fusebox won't do what you want. The idea is that a heavy battery cable goes to the stud at the bottom and the individual circuits are fused from that.

On a series, each fuse has individual wires going to it, and some go through the ignition key. Half the circuits have no fuse at all!

What you need is a basic 4-way fusebox with 8 separate terminals.
 
FlyingPete said:
This fusebox won't do what you want. The idea is that a heavy battery cable goes to the stud at the bottom and the individual circuits are fused from that.

On a series, each fuse has individual wires going to it, and some go through the ignition key. Half the circuits have no fuse at all!

What you need is a basic 4-way fusebox with 8 separate terminals.
Click to expand...


So is it worth just putting that to one side and starting again? Is there any way that it can Be used?
 
A1yxll80 said:
So is it worth just putting that to one side and starting again? Is there any way that it can Be used?
Click to expand...

If you wanted to add circuits in the future it's a good place to start. Otherwise you are in to adding relays to make certain circuits switched indirectly by the ignition key. If you want to do a straight swap, then it won't be any use.
 
A simple up-grade is to use fused relays on the lights and horn. Locate them near the load (ie clsoe to the lights / horn) and wire a supply from the battery and swith the relay with the existing cicuit. This gives you a fused supply without haveing to run a lot of extra wires and it cuts the load on the existing switch and wires.
This type of thing:
https://www.ebay.co.uk/itm/12V-Auto...=133006309789af29c7519f424b49ac2fb4823edfe4c5
 
You must log in or register to reply here.

Similar threads

rustyrangie
Classic fuel pump fuse location??
Replies
5
Views
319
Mark Piercy
Mark Piercy
D
Is this a fuse on the negative?
Replies
8
Views
908
Doogal Too
D
Jazydave
Blower fans
Replies
12
Views
461
Datatek
Datatek
herby1
Advice on new blade fuses series 3
Replies
6
Views
1K
Shedload
S
P38 guy
Relay 6 and relay 7 relocating.
Replies
19
Views
1K
Datatek
Datatek
Back
Top