Bell Housing Query

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.

topcatguzzi

Active Member
Posts
128
Location
New Haw/Byfleet
Pulled gearbox back to change clutch - fair amount of oil and crap in bell housing.
Old clutch plate has some oil/**** residue round edges but faces clean.
Where might this oil have come from?
Rubber on slave cylinder perished and ripped, changed unit.
Should I just clean out housing and hope for best?
Tom
 
If you dont end up changing the seal i used wynns engine stop leak with good results, however its not ideal, im not keen on engine additives
 
If it is a three bearing then most likely crank seals and or input shaft seal.
Good luck if you change the crank seals on a three bearing, Iv'e never got more than 10 or 12 thousand miles before they leaked again.
 
Back
Top