Disco 2 Abs warning light

TorsionBhudda · Nov 15, 2018

I've just finished replacing the steering ball joints and CV on my daughters D2 I also replaced the HUB assembly which came with a new ABS wire. I have just fired up the car but now getting ABS warning light on dash!! Does the new sensor need to be married to ECU?

Interceptorxj · Nov 15, 2018

Not normally, just plug and play.

TorsionBhudda · Nov 15, 2018

It had been started whilst everything was stripped and disconnected would this make a difference?

Lazydave · Nov 15, 2018

You need to drive it. Above 7mph if i remember correctly. Light should then go out.

TorsionBhudda · Nov 15, 2018

Lazydave said:
You need to drive it. Above 7mph if i remember correctly. Light should then go out.

That’s what I was hoping to hear before I had to go buy a diagnostic tool. Will give it a run tomorrow. I did try it back and forth in workshop but not at any speed

TorsionBhudda · Nov 16, 2018

Took it out for a drive ABS light went out before I got to bottom of road

Just fingers crossed now for its MOT tomorrow

Disco 2 Abs warning light

TorsionBhudda

Well-Known Member

Interceptorxj

Well-Known Member

TorsionBhudda

Well-Known Member

Lazydave

Well-Known Member

TorsionBhudda

Well-Known Member

TorsionBhudda

Well-Known Member

Similar threads