abs light on can some one throw some light on this plz

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.

bobtail rangy

New Member
Posts
65
Location
wolverhampton
hi again. right today i have gone ahead and carried out the wire conversion on the shuttle unit. after fitting the abs unit back in place i now went for the test. turned ignition on and all lights come on then start engine and bingo all lights go out except for the abs light. so i now put foot on brake pedal and no emigo lights great. but as soon as i pull off still ok until i accelerate then all 3 amigo lights come back on. and if i repeat this procedure it does it every time. now i have tested the abs sensors by jacking each wheel off the ground and disconnecting the abs plug that goes to the wheel. i then set my test meter to ohms 20. then put each prong on the pins in the plug that goes to the wheel and then get some one to spin wheel and i get a variable reading. now not sure how accurate this is but has any one got any more ideas as to what else to check. also i have not cleared any codes now could this cause the returning problems
 
yes the conversion was a defo cause b4 i did the conversion the 3 amigo lights would not go out at all. but when i fitted the abs pump bk yesterday after doing the wire conversion when i switched ignition on all lights on then when i started it they all went out and stayed out untill i went to drive they would then only come back on when i accelerated. so i did the mulimeter test on the abs sensors and found the o/s front was low out put so changed it and bingo.
 
Back
Top