Hello. I have a new (used) D90 and the original sound system. I have reset the Alpine head unit and set it up according to the user manual. The subwoofer is "ON" but I get no sound. I played with all the settings. LPF level / SUBW PHASE / SUBW SYS1, SYS2 / Subwoofer level etc. Before I start pulling up carpet and looking for connections I wanted to check if anyone had any obvious tricks/tips. Reference - Alpine user manual which I have gone through. Thanks in advance! CDE-133BT (alpine-usa.com)
2016 Defender Audio question
- Thread starter nicholsun
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
brianp38dse
Well-Known Member
- Posts
- 20,094
- Location
- heathrow
Hello and welcome to LZ 
- Posts
- 33,935
- Location
- North Shropshire
Hi and welcome! That looks a fun head unit for OEM!!
I do like alpine
I do like alpine
- Posts
- 33,935
- Location
- North Shropshire
Is it just the sub which has no sound? Check the wires for continuity, check the ohms of the driver (while disconnected) and check the cone surround is intact. If you gently press the cone, does it move freely? (Only a few mm)
Otherwise you're best starting a new thread in the general section as we don't have a dedicated studio section
https://www.landyzone.co.uk/forum/general-land-rover-forum.16/
Otherwise you're best starting a new thread in the general section as we don't have a dedicated studio section
https://www.landyzone.co.uk/forum/general-land-rover-forum.16/
Similar threads
