1997 Wolf bonnet catch mechanism.

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
W

Wolf Pack

Active Member
Posts
320
Location
Portsmouth
it's 3 years since I pulled this apart and I, passing the 50% mark in terms of putting it back together.
I've come to assemble the slam panel and bonnet catch, but I can't see where the spring locates.

Any advice very much appreciated and pic below, assembled as it looks in the parts book, but I know that is frequently wrong:
 

Attachments

  • A wolf slam panel.jpeg
    A wolf slam panel.jpeg
    332.3 KB · Views: 88
Thank you, yes and, as I just found out after clipping it all up and undoing it all again twice, the spring needs to be in at both ends before it's all done up.
I need to adjust the two plates next and that looks like guesswork.
Have you done that before, Bob?
 
I have adjusted my bonnet because it was a bit out of line and tight to pull the release catch.
Also fitted new hinge bushes at the same time.
It will be best to just assemble and adjust when everything else is done - before fitting grill.
 
I'm a way away from that atm, but I will do it that way.

Wings & doors yet to go back on, but not that far away, hopefully in September for the wings and next week for the doors.

Hang it loosely and gradually pull it up, much like the rest of it has been.

All bushes and screws are new, as is the rest of the truck now.

This road is a long one.
 
You must log in or register to reply here.

Similar threads

chrubb
Bonnet catch return spring help
Replies
8
Views
2K
new to all this
new to all this
K2tnt
Disco 1 Wheelarch liners, bonnet release, air filter mounts
Replies
3
Views
556
K2tnt
K2tnt
Jam5good
Bonnet catch replacement?
Replies
5
Views
1K
Oldseadog
Oldseadog
R
L322 key won't turn in ignition (my fix)
Replies
16
Views
11K
Grrrrrr
Grrrrrr
M
P38A Heater box binding the flaps with pictures
Replies
11
Views
1K
Mukiwa
M
Back
Top