Search results

Not used them myself but worth a call ACD Land Rover Breakers Unit 1 Brookside Mill Oswaldtwistle Lancashire BB5 3PX

Some of the guys in our club fill the hex head with waxoil or vaseline.

Cheers. Just picked a couple up today.

Just bought the pin kit from Ebay for about £3

A bit far from me although I will be doing the Skipton spares day. May it sunshine on you and sell all your stock.

I used electrolysis because I wanted to get the holes clean inside and they are hard to do by hand. Plastic bucket from Asda etc and Soda, battery charger and leave for a day or two. And hey presto. +1 for stainless fittings. ELECTROLYTIC RUST REMOVAL (ELECTROLYSIS)

Really impressed mate. Loads of ideas and a good looking job well done.

Looks like an old thread at least three years. Wonder what hapend to the project.

Slightly bigger pictures.

Spent a couple of hours derusting and painting a bonnet I bagged off the bay.

POR 15 and Dinitrol for me

Spent a few bob on my fender the day after pay day. New wing, drop link arm brake hoses, door top, locks and the list goes on.

I used mine as a cafe at lunch time after lying under it for a couple of hours and then as shelter later in the afternoon for until the rain had gone.

Cheers guys for all the info I am looking to go and see SP in Liverpool in the next few weeks and check them out. Will stick a couple of photo's on if I buy them. The doors cost £100 for two bottoms and £49 each for the tops and then you need the locks striker etc all plus Vat so around £300...

A bit more POR 15 on the chassis. Expensive and a bit of a faff but it is good. Plus new front brake hoses on order after looking under the bodywork today.

As push button doors are so expensive to replace, I have been looking at the SP Land Rover series door conversion for the defender and I was just wondering if anyone had any experience of these or the supplier? They are £200 plus vat for bare doors plus locks, striker and window latch and I...

Well done that's just what I have done. Have a look at the Mig welding forum it is full of useful info.

+1 better waiting for the right one.

My wife doesn't drive it.

Hi Tatts when you thinking of doing the work?