Search results

Hi. I’ve got a 1966 Series 2a diesel. I’m putting in a Series 3 petrol engine, retaining the 2a gearbox - which clutch do I need, 2a or 3? Thanks.

Hi - i've searched this but can't seem to see a clear explanation about this i have a '66 series 2a that one of PO's had converted to later wings and front panel to move headlights out. i have got wing front panels and rad panel so i can convert it back. i can't see how to mount healight...

Ran it yesterday and there is also a knocking in 1st gear on over run, does this tie in with loose nut on main shaft? Where do you access nut? (Has Fairey overdrive fitted) Thanks

I have just got a series 2A that keeps jumping out of gear, mainly 3rd , on over run. Is it worth fitting new detent springs? Or would it be better to fit new selector forks and if so, can this be done without removing box, I.e by removing panel under centre seat? Or am I wasting time and...

I am having problems with dodgy left knee and don't want to have to get rid of my 110 CSW 300Tdi - i've seen the Red Booster clutch servo advertised - has anyone got one and if so, is it worth the money? More drastic route would be to convert to automatic. what are auto 300Tdi 110's like to...

i had same problem when putting in different alarm - the interior lights are wired from the alarm so that they come on when you operate the remote. You need to wire them seperate from alarm - i took mine back to alarm man to do

mine 110CSW 300Tdi vibrates about 40mph - both props been changed but still does it. If I dip clutch or take out of gear, seems to go. If I rev engine it appears - wondering if it could be clutch?

No, no judder on take up and biting point seems ok. Does not slip even when towing approx 1.6 tonne. Should have mentioned that makes same noise when stood still so rules out props, wheel balance etc thanks

Hi, have got a 110CSW 300Tdi and i'm getting a rattle / vibration sound from gearbox / bell housing area. Gearstick vibration and rattle increases with engine speed until about 2500 RPM and then disappears, does same in or out of gear and with clutch pedal pressed down or up. Could this be...

I have a 96 110 CSW and there is a vibration at around 40MPH. It seems to only really be in 4th gear. Changed front prop as this seemed worn but still same. Any ideas? thanks

I have a vibration when under load at about 40MPH - much worse when towing (approx 1.7 tonne). Have looked at prop and looks ok, no noticeable movement in splines or joints. Whilst checking over, noticed that there is approx 1mm lift in the front output shaft from the transfer box...

Can anyone let me know the capacity of 1996 300tdi 110 CSW fuel tank? I've seen various figures but not sure what is correct thanks

I had a flat battery yesterday on my 300Tdi 1996 110CSW and subsequently found a 2.5A drain from the battery. Removed all the fuses one by one (including the large ones under bonnet) and made no difference, still a 2.5A current draw. Looked at alternator and the wires are bolted onto posts...

I have just returned to Landy ownership after an 18 month gap. Got a very nice 96 110 CSW so thought I would just give my insurers, NFU Mutual, a quick ring to insure it. No chance, they would not touch anything with 11 seats. Asked them if i could just remove load space seats and then insure...