Search results

Hi I am fitting ge glass back into my series 3 truck cab. Does anyone have any itting instructions which will help? Thanks

Finally sorted, I replaced the cheap slave with a good quality slave then reverse bled with the slave unattached with the plunger pushed fully in to make sure no air trapped. Easy to bleed and working great. Thanks everyone.

thanks

thanks

yes

Thanks I give it a go.

Hi, I have fitted a new master and slave cylinder and a new flexible hose on my series 3 with 200tdi fitted. I can't get a clutch, have ezybled it reverse bled it but no joy. I have put a plate across the slave to stop the piston coming out but still no peddle. If I blank of the master cylinder...

I am fitting parabolic springs to my series 3, which (what length) extended brake hoses should I fit?

Have fitted a push switch to open solanoid to allow fuel through

Got fuel to injectors but will not fire

Yes plenty of fuel and pulsing in right order

fitting 200tdi into series 3, trying to start engine before rebuilding rest of car. Rebuilt injectors, new lift pump, new battery, timed, fuel bled. Will not fire but will fire on easy start but dies when easy start removed. Anyone near to Holmes Chapel, junction 18 M6 HELP!!

It is pulsing, will check timing, thanks

Bled all pipes even used an electric pump to make sure enough fuel, loads of fuel at injectors.

Putting 200tdi into series 3. Want to check it runs OK before going any further. New head gasket and timing belt fitted by Land Rover specialist. New battery turns over freely, fuel stop solanoid working, timing correct, fuel system bled tappits checked and OK. Tried small squirt of easy start...

Fitted a 200 tdi. into a series 3 new battery turns over freely, timing correct, fuel delivery to the injectors is good, glow plugs working, fuel solinoid is working, tried a small squirt of easy start, just a little and she appeared to fire. Any help as I am now at a loss, tap pets also...

any suggestions for alternative seats into a series 3? And any fitting tips?

Thanks Doug!

i am fitting a 200tdi into a swb series 3. Also fitting power steering with defender column. Has anyone got a wiring diagram so I can make up the loom? The column I have has Lucas 162 AS fitted. Thanks

I have a used set of parabolic springs I want to fit to S3. The bushes on the front springs are larger than standard and I have been told these are no longer available. Does anyone know where I can get a set or have any suggestions?