i doubht the copper washers have dropped off as they was a tight fit! the injectors just dropped in and i though at was it wish now i had given them a slight push to make sure they are seated correctly! but will remove them and check them over aswell!
i just guessed them, did slacken them off tonight and tighten them back up not as tight made no difference! its definatly got to be them as engine was hard to turn over! when set up! will take injectors out and put them back in again i think or get my mate to do it!
cheers shifty! will keep...
well thats nearly 3 hours of tinkering and they still tap! didnt to begin with but once it got warm they did!
noticed that even with the adjuster wound right out some of the rockers are still extremely tight! so i am now wondering if the injectors are seated correctly, but got a mate coming...
yes i did adjust them while hot, i realise my mistake now. should of adjusted them from cold!
no the timing chain wasnt off so the timing wont be out! off out to adjust them now and then go for a steady run with it!
will let you know how i get on but thanks alot shifty, your help is much...
well i did check them again when hot! turned the engine over until one of the injector rocker was sitting on the highest point of the cam then wound it all the way down and back off 1 turn! take it thats correct?
i did have to turn the engine over to remove 2 injector that shoulds make a...
just wondering if any one had any experience with this?
have just replaced my injector seals on it tonight and adjusted the cam followers as described on here! took it for a sort run and got back and its making an awfull knocking noise, slightly metalic! did have to turn the engine over to get...
well i hope these help ryder, might be able to get a few more when i go through my college notes as im doing level 2 welding for my aprentiship.
Weldability | SIF
Weldability | SIF
hi all, hope everyone is well?
need to get some front recovery points sorted, cant fit jate rings as my steering guards in the way, would these do from paddocks and bolt them onto my front bumper?
PM725 Recovery Eyes - pair - Galvanised
i bit annoyed, i could of come to day as what i was doing got cancelled! hope you all had a good day! will be nice to see the pics!
cheers for reminding me about top gear booger it sounds pretty gd!