Search results

Replace the bushes and the drop links again, it appeared that one of the drop links that were installed had a bit of play in it so all sorted now, thanks

Currently working on a 2015 L405 with a knocking coming from what sounds like the front suspension, we've replaced almost every part of the front suspension, including both lower control arms, upper wishbones, anti roll bar drop links, both air struts. Although this has significantly improved...

Thank you 👍

I've got a Salisbury rear differential on my 300tdi defender and the bearings are starting to go and want to sort it before it turns into a bigger more costly job, does anyone know what bearings are needed? Thanks

.

After replacing the head gasket on our 2.2 puma. The starter does not seem to be activating properly. But works second try does any one have any ideas what this could be, I've attached a video, possible bad starter?

Thanks for the reply, the pump does indeed have a male end going into a female end on the camshaft, and I've had it in and out making sure they are aligned but still no luck

Have just had do do a head gasket replacement on my 2.2 puma defender due to snapped glow plugs, once everything was back together went to start it and noticed the breaks were very firm after closer inspection, I realised there was oil leaking from the vacuum pump, I replaced the seal and then...

I've had a look at the master cylinder and clutch fluid all seems to be good with that and getting goo pressure at the bleed point, but thank you

I have a 2.4 defender, fo a while it has had problems changing in and out of 1st and reverse gears, recently it won't go in and out of 1st and reverse when it's running. 2nd gear is beginning to become tricky as well. I have bleed the clutch and changed the gearbox oil but made no difference...

May have to have a look at the out put shaft, as the new universal joints didn't seem to make any difference to the noise, will let you know how I get on with the output shaft. Thanks 👍

Already taken the handbrake apart and cleaned it out didn't seem to help much, handbrake now works though 😂. I've had a look and the UJs and one of them was a bit seized, cleared it out and that seemed to help but still a bit of play it it. I'm going to replace that UJ today to see if that...

I've recently replaced the transfer box on our 2.4 110 defender, as it was making a grinding noise at high revs when accelerating and it sounded like it was coming from around that area, after having a look under and seeing that some of the seals on the transfer box had gone and it was covered...

We've had this knocking for a while on our range rover l405. I know the videos not much to go on but any suggestions will help. Thanks

We have a 2014 range rover l405 and there is a knocking coming from the front on both sides. We have replaced the drop links, lower control arms and now have just replaced the air struts. The knocking noise is still there and everything else with the suspension looks fine. Any help would be...

The ECU and the immobiliser are now fixed and the car turns over just won't start

We have a 2003 Discovery, we were having problems with the ECU as it was not turning over, and we had a problem with the immobilizer. It is now turning over but will not start up. it has had a new fuel pump and a new starter motor. Any help would be appreciated, thanks

We have a 2010 2.4 TDCI Defender with a rattle coming from the engine area between 1500 rpm and 2000 rpm. we have replaced the turbo as the compressor wheel had a bit of play in it but there is still a rattling noise. we are thinking it could have something to do with the timing chain. Any...