Search results

Whoops NSR should have been NSF. Cheers! 😳

I didn't write then down but from memory the NSR was almost double the OSF in standard height. When I tried equaling them in the 'heights' tab on RSW software it was just sending the car back to the uneven height settings. I will try again tonight in the expected ranges and will report back...

Already checked white connectors and all okay,. See original post.

Hi All, I’m after some help with an EAS issue. For the past few weeks my P38 has been sitting low on the OSF wheel. Starts, drives, able to raise lower suspension with no faults. I suspected a height sensor issue even though out of both front ones that corner is the newest. Also I keep...

Thanks Datatek. I will check them over the weekend with everything unplugged. Yes fuses are all okay, those being the first things I looked at.

Thanks. I've got 12.8 volts on the good battery. When I've gone out to work on it tonight there is no SRS lamp or Airbag fault showing. Even with key in position 2 the bulb check isn't working (complete opposite to yesterday). Bulbs are okay as I've checked them with a multimeter and switched...

I have a 1997 (P registration) P38 4.6 V8 GEMS. Recently the red SRS lamp on the dash is continually on with the 'Airbag Fault' message in the digital display. Nanocom is ‘unable to communicate with ECU’ but functions on everything else on the car. I have tried it on all three Airbag options on...

Thanks for everyone's advice. So today I have checked: Battery leads and connections - all okay Fusebox okay and no smells of burning All fuses are sound Connectors to ECU are in perfect condition with no evidence of dampness or corrosion All earth points okay Checked ground to pins 4 & 5 on OBD...

Thanks. Yes, ignition ON when using Nanocom. Had a quick look inside the ECU holder without removing plugs and no signs of anything untoward. I will however have a better look tomorrow. I am also seeing ABS and AIRBAG fault warning messages in the LCD on dash. Forgot to mention on my original...

Yes, OBDII socket and pins are all new. All have been rechecked for security and are fine.

Hi All, I am new to this forum and I'm hoping that someone can help me out. P38 refused to start the other day. Not cranking and check engine light not coming on. Reached for Nanocom to try and reset comms between BeCM and ECU. On doing so the Nanocom refused to link up and keep getting the...