Search results

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
  1. G

    clutch release point

    Hi, after changing my clutch master and slave cylinder i adjust my clutch like workshop manual. My question , the clutch pedal was pressed and open/release 4cm before the pedal hits the floor. Is this ok or not? Best
  2. G

    R380 input shaft stuck

    Hi, after changing my clutch at my 300 tdi, the input shaft maybe at the clutch splines , i torqued some bolts from the gearbox bell housing to enginge and dont realised that the shaft slipped in. I greased it with some copper grease. After loosen bolts and spin a bit the crankshaft bolt it...
  3. G

    Weld Seam chassis gearbox crossmember

    Hi there, any thoughts about this Partial Welded Piece and the Weld Seam , reweld Or leave it as it is ?
Back
Top