Yes mate I unpinned and went straight in the slabs with the sensors and still the same fault so the wiring down the original place is not connected to slabs no more what do you think it is to me it’s the slabs
The voltage both sides with no sensors on are at 5.35v ish but the voltage on the left will drop right down to 0.6v when the sensor is connected and that’s joining the sensors straight in the the slabs unit so I don’t know
So if I have no sensors connected I have 5.35v on left and right if I put sensor back on right I get voltage of 5.30v ish but if I connect left sensor the voltage just drops to 0.6-0.8 volts even with the sensor form the right that works I thinks...
So I swap the sensor form the other side and made no difference still the same fault so I fitted the two sensors straight to the slabs and still the same fault even if I swap sensors does this mean the slabbs it’s done for ??
So today I put hight sensor for the right to the left and still got the fault code of supply out of range. I decided to fine the wires on slabs unit and I fitted the height sensor in cab just to make sure it’s not the wiring at fault but still no...
Okay that’s great I will try and swap them tomorrow and see if that make any difference I think I have done this already but I can’t remember. You have any wiring diagram for the left hand side ride hight sensor cheers
Hi I’m new to this page I need some help I’ve put air back on I’ve fitted New ride sensors new plugs and new bags. I’m now getting a fault code of rear left ride hight supply out of range. The right side is reading 142 and the left is still...