no i havent changed them, i will drive a bit like it is and will check the nuts, at least they don-t make any noise like it was before, so its ok for me, thanks
How did you fit the rotating part with the wheel studs on ??
the hub with the wheel studs placed on the bottom of the press, the rest with bearing on top and pressed in
i don't understand what you mean, i got the bearing out with the press and the bearing in with the same press,
i found a youtube and did exactly the same thing , i have done some bearings before and never had a problem, i think 400Nm is a lot, i...
bonjour, today i changed the two rear wheel bearings with a 10 tons press, no problems for that but,
a new driveshaft nut which must be set on 400Nm i think i was on 100 Nw and i can't turn the hub anymore
i went back to 50Nm and can turn the hub...
in the mean time i did the thermostat solution with the gates one, thanks for that nodge,
took me one hour to get the thing into the ,,small,, hose but now the engine warms up like it should
Nodge; the window doesnt drop,
andy. no i havent change the motor, the wiring must be ok because the window goes up and down all the way with switch- key- or doorhandle, only by 2cm each time, ok for the sensor story, ill try to find an other...
bonjour i changed the whole mechanism and no difference with the old one, when i open the door it goes down 2cm
when i close- nothing and manuel cm per cm and no wiper, i check the window motor its ok- so i have a problem-
fuses are ok but no...
hi, the window mechanism looks ok, the window goes up and down with the button but only cm by cm
when i open the door the window falls 2cm but when i close i have to use the key or button to put the window up, so no wiper fonction, you think its...