Recent content by rock-sliders

thanx m8 1.45mm is all i needed as hav striped pumps on other motors is 30deg to zero defo correct tho as it sounds alot???

No I haven’t undone it yet but the motor has loads a miles on it and as we all know pumps wear and go out of time on there own And the fact it’s sitting in the bottom of the segments’ in a different place than it is on another pump that I know it correct makes me suspicious

any one know how to dial in a bosch pump on a 200 tdi got dti gauge ect just cant find any settings anywhere

britpart gets a lot of stik from people who have just herd people slagin them off and like to join in s**t stiks if you throw it hard enuf and readin most the threds on here im suprised britpart acualy sells any parts at all i agree some of ther stuf is cheep crap but every one who i hav asked...

turbo solutions darlington his name is tim and you wil be suprised how little a reconed unit wil cost you

if you look on ebay it will seem if you take it to bits and put spares or repair in the title it will fetch more???? ive seen absolute wrecks with the engine in the boot and rotten chassis going for around £1000-£1500 while auction ending within hours a landy with full mot all redy to go for...

just thout id ad my disco gets lots of hammer and i hav had fitted ap clutches britpat clutches and valeo clutches the only one ive had probs with was valeo (center came out) ap cluch was fine but the bite was very high so if you just toched the pedal it wud slip but stil out lasted til my...

is there room for a little one?? or maby 2

dont forget to tel every one wer u gotem fish :)

wd40 dusnt conduct electricity so wud be fine but must be dryed of after as dust and crap wil stik to it and turn into grinding paste and naker it again

what solanoid are you useing? if you wan i can send you a diagram

hi every one to put the record straight it is illegal to fit a non type approved tow bar to any vehicle manufactured after 1st aug 1998 any vehicle made before that there is no law in place to say you can not just simply make your own tow bar and fit it to your car with your car been a 98 id...

ive acualy done the drive with nuts lose trik before but yes its blody dangourus last time i did it was on a merc car had to drive up to the closest roundabout and went round and round until it came lose then stoped and niped up the nuts and went back to the garage only to find the blody wheel...

standard disco is 1700mm customers with flexi arches normaly ask for 75-100mm off eather end and are usualy running 33" tyres sounds a bit od as your doin it arse first the reson people put cut there arches is to clear big tyres which then leavs ragy edges so then thay have to put on flexi...

shurly you wil know that meshurement wen u hav purchased the arches and fitted them???????