Recent content by Randometer
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
-
Blimey they want the old inj. pump as WELL as the cash for buying the remanufactured one!
They don't want much do they?
-
I can get a new one for a bit less than that too.
-
Maybe it's worth buying a spare inj system block while that gets fixed?
Any ideas who is worth trusting on that?
-
Just went to start my lannie, it started after about ten seconds of turning over (which has become common since about 12 months ago). Checked underneath it... spot of liquid and drip drip drip.
I was hoping it was maybe the lift-pump (I've got a spare) or the fuel filter being loose.
Popped...
-
Failed on the crossmember?
-
Will do, there's no chance of it being leaks, but it does get crazy condensation that drips down.
-
So the inside roof of my 110 is a bit of a pain in the ass to keep dry from condensation.
Can anyone give recommendations about the best liner to use? Right now my roof is literally just bare mental on the underside in the rear cargo area. Only in the front is it a proper liner.
The genuine 2nd...
-
I've got some rust that's getting terminal at the capping area (just adjacent to the doors where the upper body-section meets the lower body section) on both sides.
The good news is I've got some galvanized capping, the bad news it is a garage job to get it fitted as I'm told the entire roof...
-
Any new pics of the beast?
-
Well the problem has gone away, I had the injectors cleaned but I suspect it was just some watery gunk in the top of the fuel-level / tank.
-
-
Hey thanks for that, I'll check that out later. There's no white smoke that I've noticed when it cuts out.
-
It is indeed, hence why I put it in this little part of the forum. :)
-
Thanks, is that under the engine to access or from the top?
-
Was it the injector pump solinoid on the lift pump or the main injection system?