Recent content by pete969
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
-
P
Did you sell this in the end?
-
P
Any update yet?
I'm about to do exactly the same...
-
P
Hi all,
My car is immobilised and won't start without inputting the EKA code.
I believe the BECM is not sending a code to the Gems ECM - the BECM is currently locked so I can't see the key code stored.
The ECM has a permanent P1621 DTS. I have done a relearn, to no avail.
I realise it may...
-
P
It has an O ring to seal it.
FYI: To stop oil leaking or misting out, Use a 20+ year old genuine LR part rather than a new aftermarket O ring.
-
P
Well done no 7. Hope you got what you wanted for it.
Test drove one today but it overheated and blew a hose on the test run. Took up most of my day today!
-
P
Tony,
I'm in Nantwich but can't get to you until next week, at the moment.
Pete
-
-
P
Had it recovered to land range services in Middlewich Cheshire.
They're gonna plug it in for £24ph + vat. That's a good rate!!!
-
P
I've tried its EKA code according to the handbook. Had Asda breakdown out who also tried the same and a maxi code reader on it which showed no fault codes!
The message board however states "Alarm fault "and the rev counter remains stationary when cranking which suggests crank sensor fault.
My...
-
P
12.8 volts. Good battery cranks forever
-
-
P
Codes were:
P1179
P0326
P0331
P1508
P3999
-
P
Do you know anyone local to me in Nantwich?
I used a small one from a local garage just for engine codes and got something like:
Steeper motor.
Max negative airflow mass correction fault
Knock sensor continuous knock / performance.
Actual P codes written down at home.
My problem is car won't...
-
P
Can anyone help?
This discussion might cure my non start problem. I've searched on non starts and got nothing. Using Tapatalk!
Hi all, help please,<br />
<br />
Fitted a replacement V8, got it Mot'd when it started to miss fire, then drove it home 6 miles when it died under load, testing the...
-