Recent content by lloydiee123

Is that the braided hose that goes from the pipe coming of the master cylinder and then attaches directly onto the salve cylinder?

After fitting new parts

I am bleeding it as I have recently changed the slave cylinder and had to replace the oil reservoir, I have tried going through the bleeding process multiple times on the clutch slave cylinder but get no oil out?

Im having great difficulty bleeding the clutch on my land rover series 2a. I have connected up a bleed kit to the clutch slave cylinder and loosened the bleed valve but I am getting nothing coming through? The reservoir is full but I don't get any fluid coming through? Any help would be greatly...

Sorry I should of added it is on the drivers side?! Any advice would be helpful?

Yes of is on the drivers side

I am having great difficultly with the replacement of the clutch slave cylinder on my land rover series 2a and I have have removed the floor board but that doesn't seem to have helped at all! If possible could somebody give me some advice? Thanks Will

Thanks so much martin1512 just sorted out the firing order and shes up and running again!!!!!! :)

Ok thanks and the mound on the top right of the dizzy does that go to cylinder 4 or 2?

I just had a look at the manifold and all I can see are the words Firing order?

Is the firing order on the dizzy cap as follows: 2 4 1 3

It happens when trying to start the engine as it doesn't fire it only seems to fire in the carburettor? The firing order is definatley correct

My land rover series 2a's fuel is firing in the carburettor recently it hasn't been firing at all but I recently replaced the spark plug and for reasons beyond me the fuel seems to be setting a light in the carburettor somebody please help thanks, lloydiee123

Ok thanks

so how can I adjust the timing to get it correct? thanks