Recent content by Jazbar

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
  1. Jazbar

    1996 P38 4.6 SRS crash sensor test

    Thanks grrrrr. Already done that.:)
  2. Jazbar

    1996 P38 4.6 SRS crash sensor test

    There are 3 wires on each front crash sensor so I presume I'm looking for an open circuit between any combination of the 3 terminals?
  3. Jazbar

    1996 P38 4.6 SRS crash sensor test

    The SRS indicator has 2 bulbs. One stays on, the other flashes continuously while ignition on and engine running.
  4. Jazbar

    1996 P38 4.6 SRS crash sensor test

    Morning all. Wonder if you good people can help me trace an SRS problem. Symptom: SRS light flashes. Airbag fault in display- this can be cancelled by stalk button. So far: Checked connectors in footwell. Replaced airbags. Checked rotary connector. I'm wanting to test the continuity of the crash...
  5. Jazbar

    1996 p38 EAS

    My apologies. Still new to the forum lark! I can confirm good continuity between pin 8 and the relay winding, relay itself and return. So I guess I need to start hunting elsewhere. :(
  6. Jazbar

    1996 p38 EAS

    I'm getting "good idle". Eas suite works fine on my other p38
  7. Jazbar

    1996 p38 EAS

  8. Jazbar

    1996 p38 EAS

    I'm using a borrowed hawkeye pro and using the pc eas suite. After reading your previous comments, I'm starting to wonder if I'm chasing EAS ghosts that aren't there. I'm not with the vehicle at the moment. Eas suite shows no fault codes. It will energise the various valves just not the pump...
  9. Jazbar

    1996 p38 EAS

  10. Jazbar

    1996 p38 EAS

    Work performed so far: checked & confirmed continuity to relay on fuse board from eas ecu. Confirmed relay function. Confirmed pump running when shorting relay switch terminals. Replaced eas ecu and delay relay with good working parts. Checked white plug in passengers footwell. Replaced entire...
  11. Jazbar

    1996 p38 EAS

    I've checked connectors, checked white plug in passengers footwell. Replaced ecu and delay relay with known working parts. Could becm cause this?
  12. Jazbar

    1996 p38 EAS

    I've switched over a whole known working eas pump unit complete with valves and driver. So that would eliminate thermal switch?
  13. Jazbar

    1996 p38 EAS

    The compressor runs. I've tried a known good eas unit. I have eas light on dash but no faults stored
  14. Jazbar

    1996 p38 EAS

    I've tried a known good fuse board
  15. Jazbar

    1996 p38 EAS

Back
Top