Almost done, Just needs testing out, that's the biggest job, the big thing is I still have the original steering wheel and that the whole idea of it all, it looks like it should!
These based off a series 3. Had to chop the corners off to go over the lip so to sit flush.
Also I have added extra light to each side so have 2 fog & reverse lights.
Only 1 fixing as tapped into the thick cappings.
There is not much room down...
Think man! Without one how else do you run all the cables up to the roof lights you don’t need!
I got my original mushroom top one galvanised and am planning on doing the same with the one for the station wagon. I just need a new tube as the one...
Think they been done in round bar,vertical.
Do same design as fronts with fold round tops & sides.
My lights are different & no standard light guards fit
Don't know yet mate, need to have a proper look. I checked the rubber coupling on rear prop and its got a few hairline cracks around the bolts so think I'll be ordering one of those regardless 😅
If the floats are not set right or stick they will over flow. Some time as tap with the end of a screwdriver handle would sort it.
Where else so you think the fuel could be coming from?
Been about 30years since last looked at SU carbs in anger
Few thoughts… (up to early for the brain cell to be working fully)
the floats should stop any fuel through the over flow?
If the pump is an interrupter type it should stop pumping or slow down once carbs are full.
Standard pumps are mormally 6psi. Good enough for v8. If you have a rubber pipe near the pump just squash/restrict with grips & pump should stop.
Photos of pump may help.
And I think your problem is float height settings.
How are the tips of...
I think I have the shot now! I managed to get it myself. So for now all good! Just got the underside of the tub (supports etc) to get in then I can finally put the tub to rest and get on with the rest of it!
Thanks for the offer though!
Matt
I don’t like keeping count. It makes keeping the vehicle even less justifiable than it already is! I have all the paperwork and could add incoming wanted to. But I feel the actual Figure would make me sick!
Cheers, it’s had four new General Grabbers yesterday and flew through MOT today without a single advisory. Garage said emissions really low and chassis solid. Happy Days!
Ahh thank you! Thought about it a few times. Front light guards easy, can go in one of the top or bottom fixing plates.
If anyone here would like anything ive made ping me a message can sort something out!
Was looking at lightguards again, love the ones I had on my old 110 and thought Id challenge myself to draw and make them this time!
First prototype, simple 2mm mild.
Added some more detail and adjustments for 4mm stainless
Involved having...
You should make the center line bigger and cut a logo mark out. Time for you to start a little business
Same with the head light surrounds. Find a flat edge
Got stuck in a gate. Its rather sore 😅
I was thinking about some today actually but not sure. Ive got the traditional plastic ones which I treat as sacrificial. They have saved my leds a fair few times other the years.
Not sure if id want a big...