Recent content by chris freestone

.

thanks

Hi hoping someone can do me a huge favour and check some chassis measurements for me please. I’m looking for - bottom of chassis rail upto bottom of A-frame crossmember and distance from back of A-frame crossmember to the brackets just behind it. Cheers on 1986 90 I’m replacing the cross...

Hi again guys, I need of some advice on how to do a chassis repair on my 90. The area in question is under neath the bump stops, they are rusted right through on both sides What I'm wondering is how you would go about repairing it, I have a friend who can weld well but the question is how...

Hey guys ive recently gotten hold of an old set of 17" -8" steel modualrs than im refurbing. Im lookin at gettin some new tyres amd usin em on my 90. But they look a little big to me as my 90 is standard height, can I get a set of tyres thatl fit these rims and my truck?

ive just finished strippin down my old 200tdi engine wich im plannin to get rebored and rebuild..... whilst doin this ive found loads of sludgey oil stuff in the basket by the the oil pump and no3 bore was considerably more worn than the others.... so im suspecting there may be a blockage in the...

procomp shocks that is sorry

hey there does anyone know the right part number for standard height rear shocks for 90? ive ordered some offline and im not sure i got the right ones? cheers

does anyone know what size circlip holds the wiper motor gear on its shaft, have lost it and need to buy a replacemant? thanks

managed to do it with a socket n hammer in the end :-)

thats my worry, there wld be ummm repurcutions if i broke works vice

heya guys im in the middle of repacin my panhard rod bushs.... ive managed to knock the old ones out witha hammer and chisel and im now onto fittin new ones. question being i dnt have access to punch just a medium size vice at work wich i realy dnt wana damage durin the process. so how hard are...

what do you nean inset?? theres a shaped duct on the inside to fit around the heater box wich bolts onto the wing on the inside... wich is what i need to cut the hole to fit for and the snorkel mates to this on the out side with its own bolts further out.... thats right isnt it??

i need to cut the same hole as a tdi wing would have i have all the tdi fittigs to go on the inside as well so ined the same shape and hole in the right place

hey guys im about to fit a safaristyle snorkel to my defender.... first job isto cut the hole in the wing..... can anyone tell me the dimensions on exactly where to cut this hole or where i can get a stencil? i thanks guys :-)