Recent content by bugsb

regret no miss it no good fun while i had it and easy to repair but dont miss it Ron

i am sure i read on a post some time ago it was 160-165ml so your not far off the mark as it has to has some air in the vcu as well Ron

this one is about to come out worth sending them an email looks very promising www.pscan.eu Ron

it sounds like it needs a washer as used on the rover ball joints to lock it in place or some thing similar and a reverse thread Ron

if you know anyone with a t300 i got the eka code and programed 3 fobs to the car if any one around northants ever wants them doing it only takes 3 mins to do and no charge thats for the 2 button fob not foumd out how to do the pectron ones yet Ron

i found when i did mine white spirit did the trick as it comes out with the silicon it evaporates so you can then measure how much to put back as to the silicon to buy i will try and find it if you are replacing with the 30000 nearly forgot i use compressed air to force the spirit in the vcu...

not sure yet as i have the van and the mrs has the mgf i have plenty of time to look around may take mths may evan end up with another freelander yet Ron

sold my freelander last week not sure what i will get next but will still be playing around with a vcu i have learnt alot on this forum over the last year and will still join in at times all the best to you all Ron

as above very simple then get that k-seal out of the system i have seen on other forums of it over time if left in clogging the jiggle valves Ron

with me it was trial and error i drilled the holes removed x amount and replaced with pure silicon oil it takes some miles for it to mix in then the wheel up test if that fails you have to remove more and add more oil each vcu will be different so its at your own risk as was said on another...

cant promise i will get it done but if i get time tues i will open one up and measure how much fluid is inside i found that if i mix white spirit with the old silicon over 24hrs it all evaporates so i could in theory clean one out with white spirit leave over 24hrs and see what is left this may...

its not something i would like to try in case it causes a blockage it would be at your own risk evan though you have changed the oil filter if there was so much gunk in the engine its worth fitting another as it may well be clogged up again Ron

any good cleaner will do i used a jet wash on my sump in and out once its all done and clean if the car is running ok then use an engine flush for upto 100 miles i had mine in with new oil and flush for 200 miles have you had the rocker cover off to check that oil is getting to the cams also...

if the oil was lumpy i would have the sump off and clean the pick up filter and clean out the sump as you could well have a blockage and no engine flush is going to remove that Ron

i would look into it if i was you as insurance may be involved would it not be better to hire a trailer or transporter lots of them around for self drive hire Ron