1. oldtel48

    P38A misfire

    good morning all you wonderful persons I have a a P38 range rover 4lt V8 petrol 2000 year model auto gear box The righthand head gasket failed about 3 weeks ago so stripped it down and did both head gaskets. All of the faces looked good and flat after cleaning, put new valves all round in...
  2. oldtel48

    P38A door lock will not open inside & out

    I would if I could but I don t know how sorry I have spent the last 5 years stripping it down to the bare chassis welding the chassis in 2 or 3 holes it was not bad a condition other than having to remanufact a new rear cross member
  3. oldtel48

    P38A door lock will not open inside & out

    I think the green ones are for the rods the one I have purchased is white keep fingers crossed thank you for pointing it out will let you know how I get on
  4. oldtel48

    P38A door lock will not open inside & out

    Thanks for your help I went out and tried it again and the blessed door opened so was able to take the door card of. From there it got a bit complicated, got in touch with my supplier and was told that I needed to buy the inner door handle £80. Went on line and found the land rover part No...
  5. oldtel48

    P38A door lock will not open inside & out

    It must my age but I am sorry I don t understand the wit I did really think the site was to pass on help but to help one another now days it not COOL i assume that s the trouble with being an old fart
  6. oldtel48

    P38A door lock will not open inside & out

    this is the first sensible reply. Hope to fix with part No FVF10002L waiting for it to come It good to hear from you thanks for jour conser
  7. oldtel48

    P38A door lock will not open inside & out

    thanks for all your very funny comment I have now sorted it out
  8. oldtel48

    P38A door lock will not open inside & out

    hello fellow range rover owners I have a problem with the o/s door lock on my dear range rover P 38 4 lt v 8 petrol Problem is I went to open drivers door from inside and the handle went clonk it lost its spring leaving it in the pulled out position I open the window to open it with the...
  9. oldtel48

    P38A Ball joints

    I have had a lot of parts for britpart and been very satisfied with except for the maff sensors as I mentioned earlier which I must say they did reimburse with no trouble my supplier did it all for me
  10. oldtel48

    P38A Ball joints

    I must say I have had good value from britpart
  11. oldtel48

    P38A Ball joints

    I do hope I have not done the wrong thing I better sell it after I have done them
  12. oldtel48

    P38A Ball joints

    Tell me where they britpart
  13. oldtel48

    P38A Ball joints

    I think I shall have to put a new axle on as I believe this is the third one’s,you can only put 3 sets in
  14. oldtel48

    P38A Ball joints

    I have put britpart one’s in just hope that they are better than the 3maff sensors I had on warranty thank goodness
  15. oldtel48

    P38A Ball joints

    Are you replacing the top and bottom ball joints I have just done the offside ones on my motor got to do the near side this week what a job best of luck