Head bolt tightening sequence

I decided to get a victor reinz head gasket for the k series but the tightening sequence on the sheet in package is different from the haynes manual.

This is the victorreinz tightening sequence

9 5 1 3 7
8 4 2 6 10


Does this sequence look correct or should i go for the one in the haynes manual.

In RAVE this is tightening sequence.....

The rave tightening sequence is the same as the haynes.

The victor data sheet gives a different sequence so not sure which to do.

Cylinder head gasket from manufacturer Victor REINZ is MLS ???

i always went with rave, haynes.

I was told the victor reinz gasket is MLS with a shim already bonded to it.

Follow the Rave sequence.
In you first post numbers 7 8 9 10 are wrong compared to the sequence I'd use.
Also I tighten all bolts to 20Nm then 90° 4 times.