Td5 suspension fault

Hi,

Looking for a little advice regards rear air suspension.Have searched all old threads and read and followed Battenburg's definitive guide.Had the usual sagging rear and read his thread about my options.Sprayed soapy water,no visible leak,so changed sensors as per instructions.Started car back up,all level,raised right to top and lowered again.Now have no sag thankfully,BUT one side seems to be sitting lower than the other.Have measured floor to wheel arch and there is a 3/4 inch difference.Still drives ok but just looks a little strange.Any ideas please,as to what i can do to sort this.Thanks in advance.

ride height sensor?

you will probably need to get heights recalibrated. computer job.

You'll deffinetly need height recalibrated ....though u can try to swap sensors between them if they are quite new....maybe u'll get lucky....if after the swap the height will be uneven then u must plug in a tester(nanocom, T4, rovacom, autologic..etc)...hawkeye for the time being is not able to do that

If you done the ride height sensors your self did you disconnect the battery first? Like the other members said computer recalibration sounds about right. @ a guess I think normal ride height should be around 33 inches from floor to arch.

Thanks for your replies,can i ask Landybandy,no i did not disconnect the battery,is it worth trying that again,and then unconnect and re-connect the sensors