Istalling a new manifold TD5
- Thread starter Mpower!
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Hedgehog70
Active Member
- Posts
- 161
- Location
- Leeds
That happened to me as well. I just drilled it out and used a nut and bolt instead - No problems 2 years on. Much easier and cheaper than replacing the manifold
T
T
Hedgehog70
Active Member
- Posts
- 161
- Location
- Leeds
Changing the manifold is not difficult. If you have a/c you will need to remove the bolts holding it in place and drop the belt off so you can access the front bolts. Turbo heat shield will also need to come off. I recommend that you soak all the mainfold studs and nuts twice a day for a week before removing them otherwise you could snap one.
Other than that just make sure you get a new manifold gasket as well as one for the turbo joint
T
Other than that just make sure you get a new manifold gasket as well as one for the turbo joint
T
sierrafery
Well-Known Member
- Posts
- 17,085
- Location
- Arad/Romania
sierrafery
Well-Known Member
- Posts
- 17,085
- Location
- Arad/Romania
I help u with that too m8, inlet u said... inlet u got
Here u go with the exhaust too:
Here u go with the exhaust too:
goondoogg88
Member
- Posts
- 36
- Location
- Dursley gloucestershire
how do you remove the air con unit, and belt. ive undone 4 long bolts i think are in the air con unit, but it wont move?
jamesmartin
Well-Known Member
- Posts
- 91,879
- Location
- louth lincs
its on dowles might need levering
