Front seat mounting frame

I have a 1995 Disco 300tdi. It has at some point in its life been fitted with what I believe is RRC front and rear leather seats with arm rests. The front seats are fully electric (comfy, but just dont suit the vehicle and are a tight fit against the doors) and are fitted on what i think are the original disco seat frames that are mounted on the floor.

Does anyone have a pic of the frame that Disco front seats are mounted onto? So i can be sure that some idiot hasnt gone too far and choped out the disco frames.

I am looking for Disco front and seats to replace the RRC ones, so they will be up for grabs as soon as I find replacements.

cheers

You got to be careful with the front seat mounts in early 300s,there was a changeover period to the later type .I would be glad to trade you some disco cloth seats for some RRC ones but Im at the other end of the island...........

Have you searched this yet? It has come up a few times before in more detail than I can give,and sorry,I dont have a pic to hand.Good luck - and if you are in my part of the world,remember those armchairs !

The mod to put RRC seats in usually leaves the frame intact but you weld a plate onto it to fix the replacement seat to. The rears were a straight swap.
I have been looking for RRC seats for a while, none about. Unfortunately, like Shocker, I am a bit far away, and he got in first.

sounds like i have the frames intact, and from looking at the plate the RRC seats are mounted on it has been bolted to the Disco frame. The RRC seats will more than likely be going on ebay at some point once i can source a front set of Disco seats.

Thanks for the replies guys.