electrical fault

Hi all,would apreciate some help with my problem.My alarm goes off all the time,when i remove the key all of the warning lights stay on,the interior lights come on when they please and every now and again when i turn the key there is nothing.would be gratefull for any ideas.

I might have an ideea if it's a Disco 2.....for Disco 1 i cant overtake the knowledge of....e.g. mr. Discool

sierrafery said:

I might have an ideea if it's a Disco 2.....for Disco 1 i cant overtake the knowledge of....e.g. mr. Discool

Click to expand...

i have removed the egr.could this be my problem.i have a disco 2 td5 1998.

sierrafery said:

I might have an ideea if it's a Disco 2.....for Disco 1 i cant overtake the knowledge of....e.g. mr. Discool

Click to expand...

According to their profile the OP's got a :

Current Landrover?(s)
1998 disco td5

thecroftster said:

i have removed the egr.could this be my problem.i have a disco 2 td5 1998.

Click to expand...

The EGR has nothing to do with the problem u described....... my first guess in this case is related to this one >
"The passive remobilisation exciter coil consists of a coil around the steering column lock. The coil energises to create a magnetic field when the ignition is switched to position II. This coil activates the handset initiating the mobilisation of the vehicle.
Input/Output
The input to the passive remobilisation exciter coil from the BCU is a 12 volts 125 kHz sinewave. The passive remobilisation exciter coil also receives an ignition controlled power supply via fuse 20 (15 amperes) located in the engine compartment fuse box. On receiving these signals, a magnetic field is generated which activates the handset
to produce a remobilisation signal. This remobilisation signal is transmitted to the remote receiver and onto the BCU to allow the engine to start".

Anyway alarm problems on Disco 2 are hard to diagnose/repair without a proper scanner which has programming abbilities for the BCU.

with you saying ignition i have just been out and had a play.upon jiggling the key with ignition on the warning lights were flickering.in your opinion would it be a new ignition or just the switch.

thecroftster said:

in your opinion would it be a new ignition or just the switch.

Click to expand...

IMO is just that coil(jiggle it's multiplug before u try something else) > it could be the "key in" sensor too who makes u tricks